INSTALLATION INSTRUCTIONS
Programing Instructions
PLEASE NOTE: These modules are VIN locked for
single use.
1) Start the vehicle. Allow it to run for 20-30 seconds
before proceeding to step 2.
2) Plug module into OBDII port, located under the
dash on the driver’s side, and wait to see a
GREEN LED on the module. Programming is
completed.
3) Unplug the module from the OBDII port. DO NOT
DISCARD.
Step 31: Test the system. Start vehicle and shift into
Reverse in order to check that all connections were
made properly. If all of the connections are correct you
will see the camera image displayed on the factory
display screen.
To enable or disable the camera input,
select from among rear vision options in radio settings.
Step 32: Reassemble vehicle. Follow your disassembly
steps in reverse order, taking care not to bind the
harness wiring when reinstalling trim.
NOTE: This camera has parklines or non parklines
and mirror image or non mirror image options.
Grid line options: Default setting is to display grid
lines. To remove the grid line display, connect the
two green wires near the end of the camera
harness.
Display options:
(Not to be used in this application!)
Default setting is mirror image display for rearward
facing camera (rear view) installation. To change to
non mirror image for forward facing camera (front
view) connect the two white wires near the end of
the camera harness.
Green and white wires on the camera harness.
9002-8847 Instructions 6-10-19.docx
Page 7 of
7
KB
