Dual Mount Universal Kit Aftermarket CMOS Camera with Optional Parking Gridlines
Installation Instructions (Kit # 9002-7601)
Step 9: Secure Camera Harness to existing vehicle
wiring. This will minimize the chance of binding or otherwise
damaging the harness (Recommended: Wire Ties or Electrical
Tape.)
Step 10: Connect Chassis Harness red wire reverse
wire and black to clean chassis ground.
Step 11: Install aftermarket display/ Navigation
display as per instructions (if required).
Step 12: Connect the male RCA from the Power
Harness to the “Camera IN” on the aftermarket
display/ Navigation display.
Note: Connection to female RCA connector shown.
Step 13: Test the system. Inspect that all connections are
proper and secure. Clear all loose items removed from the
area around the vehicle and turn ignition key ON to test
system.
Step 14: Adjust Camera angle (if necessary). Loosen
camera screw using supplied Allen wrench to aim the camera.
Tighten screw at desired adjustment.
Step 15: Reassemble vehicle. Follow your disassembly
steps in reverse order, taking care not to bind the harness
wiring when reinstalling.
OVERVIEW
REQUIRED CONNECTIONS
Wire
Color
Polarity
Function
Connection
Red
12v +
Reverse
Commonly found in kick panel
Black
-
Ground
Good chassis ground
1: Select and Install Camera Bracket. Choose License Plate Bracket or Alternate Camera Mount Bracket. Place camera in desired position to confirm
fitment (Note: Some states prohibit items blocking the license plate; check local authorities to confirm legal status for your specific application).
License Plate Bracket: Remove vehicle license plate. Reattach license plate securing bracket behind.
Alternate Camera Mount Bracket: Remove camera from License Plate Bracket using supplied Allen wrench. Attach camera to Alternate Camera Mount bracket
and apply supplied self-adhesive foam to mount. Use Template below to locate Alternate Camera mount on the vehicle: Clean vehicle surface and affix by exposing
self-adhesive foam. RECOMMENDED: Permanent attachment using small screws.
2: Measure, mark, and drill ¼” hole for camera harness.
3: Determine location of vehicle power and ground. Using a vehicle specific service guide and/or wiring diagram and a multi-meter or computer-safe test
light, locate which side of the vehicle contains wires into which you will need to tap for the Power Harness wiring (see Required Connections above).
9002-7601 Instructions 6-10-19
Page 4 of 5
KB
