Dual Mount Universal Kit Aftermarket CMOS Camera with Optional Parking Gridlines
Installation Instructions (Kit # 9002-7601)
Chart A
Wire
Color
Polarity
Function
Description
Location
Red
12v +
Reverse
This lead will display
12 volt + when the
vehicle is in reverse
Commonly
found in
either
passenger or
drivers kick
panel
Black
(-)
Ground
Chassis ground
A ground
bolt is
commonly
found in the
front kick
panel area
with other
wires
attached.
Step 4: Splice the red
and black chassis
harness leads into the
corresponding vehicle
wires (Recommended:
Soldering or T-taps as
optional connection
method). Also
recommended is an eyelet
for the ground connection.
Step 5: Insert the connector end of the Camera
Harness through the hole you drilled. (RECOMMENDED:
Protect Camera Harness from sharp metal edges by applying
a small amount of silicone caulk or a rubber grommet to the
area that comes into contact with the metal).
Step 6: Route Camera Harness. Continue routing harness
to the side of the vehicle that supplies power and then
forward.
Step 7: Connect Camera Harness to supplied Chassis
Harness. The optimal location for this junction may occur at
the top of the liftgate or the inner edge of the trunk
depending on vehicle in which installation is in (Note: most
vehicles may already have existing wires passing through this
area; use this route if at all possible).
Step 8: Route Chassis Harness. It may be necessary to
remove sill plates, pillar covers, seat bottoms, side panels,
etc. In some cases even the seat belt bolts at the bottom of
the pillars must be removed (CAUTION: Any bolts removed
for safety devices must be reinstalled and tightened to
manufacturer’s specified torque specifications). Use a plastic
trim removal tool to avoid damage to trim pieces.
9002-7601 Instructions 6-10-19
Page 3 of 5
KB
