Brand Developers Limited Conrad Meier Fish Harvester, Руководство пользователя

Страница: 11 / 21

Conrad Meier Fish Harvester User Guide Page 17 Page 16 Conrad Meier Fish Harvester User Guide
If you’re fishing at night, you must use the strobe light. In dull, overcast
conditions, or late in the afternoon, attaching the strobe light is also
recommended .
The strobe light takes one D-size battery, which is included in the kit.
Note: Remove the battery when not in use.
Using the strobe light
Follow the instructions below to use the strobe light.
Step Action
1 Unscrew the casing and insert D-size battery. Replace top and screw
on firmly.
2 If operating properly, the light will flash at 1 second intervals.
3 Insert strobe light into the port provided at the top of the Conrad
Meier Fish Harvester hull .
Visibility flag
Insert the flag into the small port located just behind the hatch on the Conrad
Meier Fish Harvester hull .
Note: Ensure it is fully inserted and will not come out easily .
Always insert the flag before launching the Conrad Meier Fish Harvester. When
transporting or storing, the flag can be stowed inside the hull.
Setting up
Overview
Before you launch your Conrad Meier Fish Harvester, you’ll need to set up the
components of your kit. This process involves the following stages:
Charging the batteries
Your kit includes three rechargeable 12V batteries and a battery charger.
Follow the steps below to charge them.
Step Action
1 Plug in the charger and connect the 12V batteries. You can connect
two batteries at a time.
A constant red LED light indicates that the batteries are charging.
2 When the light turns from red to green, disconnect the batteries.
The green light indicates that the batteries are finished charging.
This will usually take 10 to 12 hours per battery.
Additional chargers are available for purchase (go to
www.fishharvester.com
).
Installing the batteries
Follow the instructions below to install the batteries for the Conrad Meier
Fish Harvester and its associated equipment.
Installing the batteries for the remote control
The remote control takes two AAA batteries. Your remote will be shipped to
you with batteries installed. If you need to replace them, simply open the
battery case at the back of the remote control to install. Be careful not to
damage the seal, or trap any dirt in the seal to ensure it remains water tight.
Se
tting up
High Visibility Nylon
Flagpost
Charge
The
batteries
Install
the
batteries
Load the
beach
trolley
Your kit
Se
tting Up