Braillo 650 SW, Руководство пользователя

Страница: 122 / 127

BRAILLO
l
B 650 SW
122
8.4 Service and maintenance
Troubleshooting Paper Roll Feeder
The Paper Roll Feeder may be considered as an independent unit, but the Paper Roll Feeder will also
supply the Printer and the S&F unit with compressed air and power.
So if the Paper Roll Feeder is turned off, the two other machines will also be turned off. The same thing
applies to the emergency switch, if any of the two is activated, everything will be turned off.
If the Paper Roll Feeder motor does not start, please check the following:
Is the green power lamp illuminated ?
If no; Is the main switch turned on ?
Is the Paper Roll Feeder connected to the mains ?
Is one or both of the Emergency switches pressed down ?
If yes; Is the paper positioned near the floor, so it is actually in correct position ?
Do also note that if the laser distance sensor is not finding anything between 20 cm and 80
cm from the sensors front, the motor will not start. Try to hold a piece of paper in front of the
sensor, approximately 30 - 40 cm away. Now the motor should start.
If the motor starts, but the paper is not moving, check the compressed air supply. The paper Roll Feeder
requires compressed air to function.
Maintenance Paper Roll Feeder
The Paper Roll Feeder will not need much maintenance. The bearings are of a sealed type and will not
need any lubrication.
The most important thing is to ensure that the rolls are clean and undamaged. Keep especially an eye
on the rubber roll. The rolls may be cleaned with a cloth moistened with alcohol.