Brahler MSI8V CDSVAN, Руководство по эксплуатации

Страница: 7 / 28

CDS VAN MSI8V
7
Important remarks
For customers in the EU and in the USA
Our equipment has been tested and complies with the requirement of the CE test. This guarantees the protection
against harmful interferences, when the equipment is operating in a commercial environment. If the unit is not
proper installed to this user manual it may causes radio interferences. Any changes or modifications not explicit
approved in this manual could void your authority to operate this equipment.
For customers in the United Kingdom
The wires in the main lead are colored in accordance to the following codes:
Green-and-yellow: Earth
Blue: Neutral
Brown Live
If the colours of the wires in the mains lead of this unit are not corresponding with the coloured markings of the
terminals in your plug, so please proceed as follows:
The green-and-yellow wire must be connected to the plug terminal marked with the letter E, with the safety earth
symbol or with green-and-yellow colour. The blue wire must be connected to the terminal marked with the letter N
or with black colour. The brown wire must be connected to the terminal marked with the letter L or with red colour.
The equipment must be connected to earth!
Safety
Check that the operating voltage of the unit is identical with the voltage of your local mains power. If a voltage
conversion is required, consult your BRÄHLER ICS dealer or qualified personnel.
Should any liquid or solid object fall into the cabinet, unplug the unit and have it checked by qualified personnel
before it will be used again. Unplug the unit from the wall outlet or set the Main Power switch to OFF if it is not used
for several days. To disconnect the cord, pull it out holding the plug. Never pull the cord itself.
Installation
Allow adequate air circulation to prevent internal heat accumulation. Do not place the unit on a surface (rugs,
blankets, etc.) that may block the ventilation holes.
Do not install the unit in locations near heat sources such as radiators or air ducts, nor in places exposed to direct
sunlight, excessive dust or humidity, mechanical vibration or shock.
To avoid condensation do not install the unit where the temperature may increase rapidly.
Cleaning
To keep the surface of the housing in a proper condition, periodically clean it with a soft cloth. Large staining may
be removed with a cloth lightly dampened with a mild detergent. Never use organic solvents such as thinners or
abrasive cleaners since these might damage the surface.
Repacking
Save the original shipping box and packing material. For maximum protection, re-pack the unit as originally packed
from the factory.
If not supplied with the equipment, a complete transportation and storage box system is available from BRÄHLER
ICS. We recommend using this system for long-term protection and care.