Skye View Post Mount Bird Feeder Kit
Copyright © 2007 Braecrest Design
FDR-001 -03 Assembly, Rev. 01
These instructions are for the assembly of the Skye View Post Mount bird feeder (FDR00103xx).
PARTS
(8) #8 x 3/4 Brass Screws
(2) Metal Supports
(1) Roof Assembly
(1) Floor Assembly
TOOLS REQUIRED
• #2 Robertson (square) screwdriver
• Ruler or Tape Measure
STEP 1. UNPACKING
Unpack the Bird Feeder kit and locate each part listed in the
PARTS list. See Figure 1
.
STEP 2. LOCATING METAL SUPPORTS
Place the Floor Assembly upright. Position a Metal Support
against the end of the Floor Assembly and centered between
the sides of the Floor Assembly. See Figure 2.
STEP 3. INSTALL BRASS SCREWS
Using the #2 square screwdriver, install two Brass Screws
through the holes in the Metal Support and into the Floor
Assembly. See Figure 3. Repeat STEP 2 and STEP 3 to install
the second Metal Support on the opposite end of the Floor
Assembly.
Figure 3
STEP 4. LOCATING ROOF ASSEMBLY
Turn the Roof Assembly upside down. Take the Floor and Metal
Support subassembly and turn upside down on the Roof
Assemby. Slide the subassembly sideways until centered on the
Roof Assembly. See Figure 4.
Figure 4
Figure 1
Figure 2
PAGE 1 OF 2
Continued on Page 2 of 2
Assembly Instructions
