Brady PAM 3600, Руководство по обслуживанию

Страница: 48 / 98

48 Printer Applicator System PAM 3600
Service Manual PAM 3600 5 Adjustments
5 Adjustments
5.1 Adjusting the Peel-off Table
For optimum print and application quality, it is important to adjust the front position and the back position of the peel-
off table exactly.
This adjustment has already been performed in the factory. Nevertheless, it may become necessary to adjust it.
WARNING!
Mortal danger by electric shock!
Disconnect power supply!
Switch off compressed air!
1 2 3
A
2 4
Figure 5a Adjusting the peel-off table
1 Peel-off table
2 Threaded pin with nut
3 Bearing plate
4 Threaded pin with nut
Adjusting the front position
Slide the peel-off table (1) to its front position.
Check the front position by measuring the distance
A
between the rear edge of the table (1) and the front edge
of the bearing plate (3).
A distance A on 52 ± 0.2 mm is recommended.
If an adjusting is necessary, carry out the following steps.
Loosen the nut on the threaded pin (2).
Align the table to the recommended value by turning the threaded pin (2).
Tighten the nut on the threaded pin (2).
Check the function of the sensor for the front position of the peel-off table (see section 5.4).
Adjusting the back position
Slide the peel-off table (1) to its back position.
Check the back position by measuring the distance
A
between the rear edge of the table (1) and the front edge
of the bearing plate (3).
A distance A on 26 ± 0.2 mm is recommended.
If an adjusting is necessary, carry out the following steps.
Loosen the nut on the threaded pin (4).
Align the table to the recommended value by turning the threaded pin (4).
Tighten the nut on the threaded pin (4).
Check the function of the sensor for the back position of the peel-off table (see section 5.4).
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
6.