Brady BP-IP300, Руководство пользователя, Страница: 33 / 75

Loading the Ribbon and Material
26
3. Press and hold the green tab (Figure 20, 3) on the material supply holder
and slide the end piece (Figure 20, 4) outward.
4. Slide the Brady labeling material roll onto the material supply holder.
Make sure material roll is installed with label printable side (up) towards
printhead
(Figure 20, 6) . Reinstall the end piece (Figure 20, 4) , which will
automatically center the roll on the holder.
5. Reinsert the material supply holder onto the bracket grooves on the
frame. Ensure the electrical contacts under the side tabs (Figure 20, 1)
are properly seated in the frame so the printer will correctly read the
material identification tag.
Figure 21, Alignment Guides
6. Thread the material under the print module, under the guides
(Figure 21, 2) and forward through the slot in the control panel.
7. Turn the green dial on the left (Figure 21, 1) to adjust the guides so they
just snug up against the labels. Do not tighten the guides enough to crimp
the labels.
8. Apply thumb pressure to the close points (Figure 18, 7) on both sides of
the print module until it latches securely in place. Once the print module is
latched in place, raise the front panel and snap it into the closed position.
9. Close the printer cover (Figure 1, 9) .
1. Green dial 2. Material guides
1
2