Brady BP-IP300, Руководство пользователя

Страница: 32 / 75

Loading the Ribbon and Material
25
NOTE: The spindle is self-adjusting and will smooth the ribbon out and
position it correctly as the adjustment wheel is turned.
NOTE: To remove ribbon from the ribbon take-up spindle, press and
hold the thumb lever
(Figure 19, 4) to compress the spindle and
slide the ribbon off the spindle.
Loading the Material
Label rolls are supplied with different diameters. The material supply holder
can hold label rolls with a minimum core diameter of 3 inches (76 mm).
Figure 20, Material Supply Holder
1. Open the cover (Figure 1, 9) , lower the control panel (Figure 1, 17) and
press the green print module release button (Figure 1, 15) .
2. Remove the material supply holder (Figure 20, 2) from the printer by
lifting it up and out of the frame.
1. Electrical contacts
2. Material supply holder
3. Green tab 4. End piece
5. Labels
6. Printable side up
NOTICE
There are electrical contacts located under the side
tabs (Figure 20, 1) on both sides of the material
supply holder. Be careful not to damage these
electrical contacts or the Brady IP Printer will be
unable to read the material identification tag on the
labels.
6
6
5
4
3
1
1
2