3
Installation
S19-120T
Bradley •
215-148CP Rev. N; ECN 17-05-039
7/18/2017
Supplies Required
• Pipe sealant and teflon tape
• Piping to 1" NPT water supply inlet
• Adequate supply pipe supports
• Minimum 4" (102 mm) drain to
accommodate 30 gallons (115 liters) per
minute discharge for shower waste
• Sign-mounting hardware
Assemble components
1. Assemble components as shown on page 4.
2. Apply pipe sealant or tape (by installer) to
all male-threaded pipe joints.
3. Bottom edge of showerhead should be
7'-0" (2134 mm) from the floor.
Connect water supply
NOTICE! Do not rely on Bradley’s Drench
Shower to support supply piping.
1. Connect water supply piping to 1" NPT
inlet on unit (piping supplied by installer).
Provide adequate supports (supplied
by installer) for supply pipe using pipe
hangers or other means.
2. Mount the safety sign to the wall using
sign-mounting hardware supplied by
installer.
5-1/4"
(133mm)
9"
(229mm)
Ø 10-3/4"
(273mm)
15-7/8"
(403mm)
7'-0"
(2134mm)
Suggested
Height to
Floor
24"
(610mm)
3-5/8"
(92mm)
