LD-5010
Installation
14
8/24/2017
Bradley
• 215-1869 Rev. B; ECN 17-11-004B
Aerator Installation
3
Red Service Key
Aerator
(0.35 gpm or
0.5 gpm)
Carefully thread the aerator into
the WashBar casting using the red
service key provided. Ensure no
leaks after installation.
A
Attach Soap Motor and Soap Container Bracket
4
Attach soap motor control box and
soap container bracket to wall using
#10 fasteners at locations shown in
Structural Rough-In drawing.
A
Install the soap pump onto gallon
container opening (supplied by
others).
B
The liquid soap pump has a rubber
sleeve that fits over the soap
container opening. The foam soap
pump has an interior white cylinder
that fits into the soap container.
This fit up may be tight. Move the
soap pump laterally while applying
pressure to seat into soap container
opening.
Soap Motor
Control Box
Soap
Container
Bracket
To check soap fitup, slide gallon jug
with soap pump into soap motor
control box. Ensure soap pump flange
is positioned below motor control box
lever and soap control box flange
is positioned in soap pump groove.
Gallon jug should rest on soap
container bracket without soap pump
pulling off of container.
C
Soap Pump
Flange
Motor Control
Box Lever
Once fitup is correct, remove soap
container with pump attached and set
aside. Soap container will be installed
in a later step.
D
Soap Control
Box Flange
Soap Pump
Groove
15-1/2"
(394)
13"
(330)
6-5/8"
(168)
12"
(305)
Liquid soap pump
shown. Foam soap
pump similar.
Soap Supply
Tube
