5
Installation
HN-200 Recess-Mounted Shower
Bradley •
215-741 Rev. C; ECN 15-03-004
4/29/2015
Install Shower and Grab Bar
2
A
Position the face place on the wall . Mark the
wall and install (18) wall anchors suitable for
use with 14"-20 machine screws .
C
Attach the face plate to the wall with the
(18) 1/4"020 x 3/4" button head Allen key
screws provided .
D
Position the "L" of the grab bar to fit the
back wall of the shower stall . Using the
flange as a template, mark the wall and
install the (6) wall anchors (supplied by
installer) for the 1/4"-20 x 1-1/4" flat head
Allen key screws .
It is the installer's responsibility to use the
correct anchors for the particular job's wall
construction.
1/4"-20 x 3/4" Allen Key Screw
Concealed
Mounting
Cover
Grab Bar
B
Connect stainless steel hoses to the 1/2" IPS
for the hot and cold water supply .
E
Secure the grab bat to the (6) wall anchors
using the (6) 1/4"-20 x 1-1/4" flat head Allen
key screws provided .
Install Curtain Rod
3
A
Measure and cut the stainless steel curtain
rod to fit the shower stall opening .
B
Using (2) #10-13 x 2" Phillips oval screws,
mount one shower rod flange 80" (2023mm)
from the floor as close to the opening of the
shower stall as possible .
C
Insert one end of the shower rod into the
flange . Slide the other shower rod flange
onto the shower rod .
D
Position the shower rod and flange on the
opposite side of the shower stall opening
at the same dimensions as the other flange .
Secure the flange to the wall with
(2) #10-13 x 2" Phillip head screws provided .
E
Install ten hooks onto the curtain rod and
hang the curtain on the rod .
60"
(1524mm)
Shower
Rod
Flange
80"
(2032mm)
to floor
