Express® Lavatory System SS-Series
SS-3/AZ/WH97TAS
Installation - Obsolete
12
4/24/08
Bradley Corporation • 215-1175 Rev. H; EN 08-805
Soap Dispenser Maintenance
Step 1: Fill soap dispensers
The two soap valves will dispense vegetable/coconut oil liquid soaps, synthetic detergents, viscous
lotion soaps, and antiseptic solutions. A 10-15% concentration is recommended for vegetable or
coconut oil liquid soaps. Synthetic detergents, lotion soaps, and antiseptic soaps require no dilution.
1. Using two screwdrivers (or similar tool), push up on the release tabs located beneath each soap
dispenser and pull out the soap tanks from the sprayhead (see Figure 7a).
2. To remove packing dust, rinse out each soap tank with hot water. Shake water out thoroughly
and allow to dry.
3. Pour the soap into each soap tank's filler hole (see Figure 7b).
4. After each soap tank is filled, position the soap tanks into the sprayhead openings and push into
place.
Step 2: Change soap type
1. Pour out all of the soap from
the dispenser.
2. Rinse the soap dispenser with
hot water several times until
all of the residue is removed,
and pump the valve until
clean water appears.
3. Rinse the dispenser with ethyl
alcohol and allow to air dry.
4. After the dispenser is dry,
pour the new soap into the
soap dispenser.
Figure 7a
Figure 7b
ACTIVATION LABEL
204-476
(one above each activation zone)
SOAP DISPENSER VALVE
S09-007
qty. (2)
SOAP TANK
133-107 (GRAY)
133-131 (PUTTY)
133-131A (COAL)
FILLER HOLE
