Installation
8170-158/1581
Bradley
• P20-125 Rev. A; ECN 13-15-016
8/7/2013
3
1
Install Anchors
A
Adjust both flanges so that the grab
bar is in the support (locked) position
(both locking pins should be in the deep
notches of the wall and floor flanges .
C
Using the mounting holes on the wall
and floor flanges as templates, mark the
hole positions on the mounting surfaces
and drill holes for mounting anchors .
B
Position the grab bar alongside the wall with
both flanges flush against their mounting
surfaces . The centerline for the floor flange
should be 3" from the wall . The centerline for
the wall flange should be 29" from the floor .
WARNING! The swing-away grab bar is designed to support a load in excess of
300 pounds. Make sure wall backing is adequate before installing.
The swing-away grab bar must be mounted parallel to the wall. It may be necessary to insert
shims under flanges to compensate for an uneven relationship between the floor and the wall.
CAUTION! Improper installation can prevent smooth
operation of the grab bar and can cause
damage to locking pins and flanges. Make sure
the centerlines for the wall and floor flanges are
the correct distance from mounting surfaces.
29"
(736 .6mm)
3"
(76 .2mm)
CL
CL
Wall
Flange
Floor
Flange
D
Install 4 mounting
anchors in the wall
and 4 in the floor .
Grab Bar
in Support
(Locked)
Position
Locking
Pin
Support
Position Notch
Open Position
Notch
