Installation
P.O. Box 309
Menomonee Falls, WI 53052 USA
800 BRADLEY (800 272 3539)
+1 262 251 6000
bradleycorp.com
WARNING
All mounting hardware is supplied. Installer must use appropriate anchors for wall construction. Wall anchors
used must have a minimum pull-out rating of 500 lb.
The electronic dispenser assembly is no stronger than the anchors and walls to which they are attached,
and therefore, must be firmly secured in order to meet regulatory requirements. To avoid potential injury, the
building owner or maintenance personnel should remove dispenser assembly from service if the mounting is
not adequately secured to the wall or if there is any observed product function issues.
CAUTION
Personal Protective Equipment (PPE) is required during the installation and maintenance of this product.
NOTICE
Before installing this product ensure that there are adequate clearances around the product in both the user
position and the stored position.
IMPORTANT
Read this entire installation manual to ensure proper installation. When finished with the installation, file
this manual with the owner or maintenance department. Compliance and conformity to local codes and
ordinances is the responsibility of the installer.
For recommended mounting height, do not exceed 55" distance from the top of the towel dispenser to the
finished floor.
Separate parts from packaging and make sure all parts are accounted for before discarding any packaging
material. If any parts are missing, do not begin installation until you obtain the missing parts.
Product warranties may be found under "Products" on our website at www.bradleycorp.com.
Electronic Roll Towel
Dispenser
2498 w/Plastic Cover
2499 w/Stainless Steel Cover
P20-227 Rev. A: ECO 19-15-030A
© 2020 Bradley
Page 1 of 2
5/11/2020
Model 2498
Model 2499
