Bradford White RG2DVMH30T6X-264, Руководство пользователя

Страница: 4 / 28

4
GENERAL INFORMATION
This water heater must be installed in accordance with The Federal
Manufactured Home Construction And Safety Standard (H.U.D. Title 24, Part
3280.707d2) or CAN/CSA Z240 MH series, mobile home. In the absence of
such a standard, the water heater should be installed in accordance with the
Standard For Mobile Homes (ANSI/NFPA NO. 501-B1977).
The warranty for this water heater is in effect only when the water heater is
installed, adjusted, and operated in accordance with these Installation and
Operating Instructions. The manufacturer will not be liable for any damage
resulting from alteration and/or failure to comply with these instructions.
This water heater is of the closed combustion type (direct venting) where all the
combustion air is supplied from the outdoors through the air intake and all
combusted gas products are vented directly to the outside by means of the roof
jack. No draft diverter (vent hood) is required for this water heater.
INTERTEK has tested a representative sample of this water heater design for
its safety of operation. The ETL listing of this water heater includes the field
installation of the following components: roof jack, air intake tube, and heater
tie down materials. These components for field installation may have been
shipped with this heater and must be installed according to these instructions
(see figure 1). No other components are approved for use with this water
heater.
This water heater has been designed and certified for the purpose of heating
potable water. The installation and use of this water heater for any purpose
other than the heating of potable water may cause damage to the water heater,
create a hazardous condition, and nullify the warranty.
Do not use this appliance if any external part to the tank has been submerged
in water. You should contact a qualified service technician to inspect the
appliance and to replace any part of the control system including the
combination gas control which has been submerged in water. See the Gas
Connections section of this manual before servicing or replacing a water heater
that has had any external part to the tank submerged in water.
CAUTION
Incorrect operation of this appliance may create a hazard to life and
property and will nullify the warranty.
WARNING
Prior to connecting the gas supply line to a gas fired water heater,
ensure that the gas supply line does not have moisture/water or
dirt/scale inside the gas line. Commonly this check is done at the
lowest point in the gas distribution system prior to gas burning
appliances.