Starting a charge
Tethered pulse home
1. Press the plug’s release trigger on the charging cable and then
remove the plug from the docking socket.
2. Fully uncoil the cable
3. Open the charging socket cover on your vehicle
4. Insert the charging cable plug into your electric vehicle (EV)
Function button
The Function button is located at the bottom of the unit on the rear surface.
With this button you can:
• Configure WiFi:
press and hold down for 6 seconds and release
• Reset:
press and hold down for 10 seconds and release
Socketed pulse home
1. Lift the flap to access the socket
2. Insert the charging cable plug into the electric vehicle before connecting to the
charging socket. Always make sure the plug is fully inserted into the socket.
Depending on the make and model of your EV, you may receive notification on your
vehicle’s dashboard (e.g. a sound, light or icon on dash etc.) to let you know your
pulse home is connected to your vehicle.
After completing these steps, charging will start. The green Status indicator will
illuminate to show your EV is charging.
pulse home status
Below are the main colours you will see on the Status indicator.
For additional information please visit
www.bppulse.co.uk/pulse-home-support
Idle
Blue
Your pulse home
is ready.
Charging
Green
Your electric vehicle
is now charging.
Disabled
White
Your pulse home
is disabled. This
function can only
be set via the home
pulse app or portal.
Fault
Red
Your pulse home is in fault
mode. Do not try to charge
in this condition. Please refer
to troubleshooting guide for
further assistance.
pulse home User Guide
11
