Boyens Backservice Jelly power pack, Инструкция по эксплуатации, Страница: 22 / 44

22
Putting into operation
Jelly power pack Edition 09.09
4.11 Pauses and operational breaks
Switch off the implement if the
operational break will be more than 1/4
hour.
After switching off, the flow-heater
provides a residual heat for some hours.
Thus, after having been started again,
the implement only needs a few minutes
to
obtain the pre-set processing
temperature.
Before longer operational interruptions
(more than 3 hours) spray the system
empty,
•
in order to save the system from
material-burns.
•
because the jelly will have lost its
ability to jelly after more than 2 - 4
hours of stale.
Immediately switch off the implement
when the system has been emptied.
Material-burns
inside the material
channel would be the result when the
system
goes on heating without
material.
Damage due to material channel which
have not been flushed (emptied by
spraying) will not be accepted as claims
under guarantee.
- Switch off the implement if the operational break
will be more than 1/4 hour.
- Before switching off the implement, ensure that it
is empty if the intended operational break will last
longer than 3 hours.
- Separate the implement from the external
compressed air source.
Spraying the system empty
- Disconnect the coupling plug (1).
- Go on spraying your pastry until only an jelly-air-
mixture will emerge the spray gun.
- Secure the spray gun (2) by means of the locking
device (3) against unintended spraying.
- Place the spray gun into the retainer (4).
- Switch off the implement.
- Separate the implement from the external
compressed air source.
- Connect the coupling plug (1) back together.