Boyd AAVID Kodiak H02 Series, Техническое руководство

Страница: 14 / 50

Kodiak  Recirculating Chiller Technical Manual
Manual# 820-0043 Rev N, 11/25/2019
13
Optional System Features
Deionization Package:
The Deionization Package consists of a factory-installed deionization cartridge. The
deionization cartridge requires replacement only when the mixed bed is depleted. For
replacement cartridges, Call Boyd’s Customer Service at 781-933-7300. This package is
offered for deionized water applications where the resistance of the water does not exceed 1
megohm-cm, and where the use of brass and copper fittings is acceptable. The deionization
package is not recommended with centrifugal pumps.
Coolant Water Filter:
This factory installed water filter removes particulate from the coolant water. The water filter is
not recommended with centrifugal pumps. For replacement filters, call Boyd’s Customer
Service at 781-933-7300.
Heater Package RC011, RC022, RC030, RC045:
The heater package is for applications requiring coolant temperature well above ambient
temperature. This package is a single set point type. The heater is activated when the water
temperature is 3

F below setpoint.
*NOTE: The heater option is not intended to provide tight temperature control, but to bring
coolant temperature up to an application's requirement.
****WARNING****
If your unit was not built with the heater package, do not attempt to retrofit it. If you do,
severe damage will occur to the unit, personal injury may result, and the warranty will be
voided.
High Purity Plumbing:
This option is intended for use with deionized water. Only stainless steel and/or plastic
components and a nickel-brazed heat exchanger come in contact with the coolant. You must
specify this option before you purchase a chiller; it is not field retro-fittable.
External Manually Adjustable Flow Valve:
This option is a valve plumbed between the supply and the return of the chiller. It allows you
to manually adjust the flow rate. To be sure your equipment is receiving
enough flow, install a flow meter at the outlet from your equipment.
External Pressure Relief Valve:
This option is for applications requiring reduced pressure. This kit contains a Pressure Relief
Valve, 2 Tees, Hose Clamps and Plumbing Instructions.