29
6
Lift and grasp the pull tab and lift the module out (Figure 21).
F
IGURE
21
Removing the lamp module
WARNING: Do not drop the
lamp module or touch the glass
bulb! The glass may shatter and
cause injury.
7
Install the new lamp module, being sure to align the connec-
tors properly.
8
Gently push the module in until it is flush with the bottom
case of the projector.
9
Tighten the screws on the outside of the module.
10
Replace the lamp door by inserting the hooks on the rear of
the lamp door into the projector and pressing the lamp door
into place.
11
Plug in the power cord to turn the projector back on.
12
To reset the lamp hour counter in the Status window, press
and hold the
volume -
button, then press the
menu
button
(while still holding down the
volume -
button) for 5 seconds.
Verify that the counter was reset by pressing the
menu
button
and viewing the counter in the Status window.
