BOXER BHL-225, Руководство пользователя

Страница: 13 / 48

4.4 WHEEL TREAD SETTINGS
Tractor front wheel tread setting must be restricted to wheel tread spacing recommended in the tra ctor Operator’s Manual.
4.5 ATTACHMENT
Ensure your tractor’s point linkage system is fitted with sway chain attaching the backhoe. Failure to do can cause the
backhoe to swing when travelling potentially causing bodily injury or machine failure.
Inspect for any worn or damaged parts between the tractor and backhoe. Replace if necessary with parts of suitable
strength and quality.
4.6 COUNTER WEIGHT
Add recommended ballast (either front weights or from end loader) to the tractor’s front -end for increased stability. Refer
to tractor operator manual for specific recommendations on counter weighting tractor.
5.1 PTO SHAFT CONNECTION (BHUF AND BHUS
MODELS)
Ensure PTO shaft is correct length; correct PTO shaft length
must have a minimal overlap of 150mm in drive position. Connect PTO shaft to tractor PTO output shaft and backhoe
hydraulic pump shaft. Check PTO shaft has suitable angle prior to operation. Angle of PTO shaft universals must be less than
25°, to prevent major damage PTO Speed 540RPM for operation.
5.2 HYDRAULIC CONNECTION (BHEF AND BHES MODELS)
Connect the Hydraulic quick connectors to the tractor’s hydraulic remote outlets. Detent tractor hydraulic remote’ s control
lever forward or back for correct flow of oil to backhoe.
5.3 FITTING BACKHOE TO TRACTOR
-Choose some firm level ground to work on -Use hoist raise the backhoe mainframe onto 3 secured stands. -Align the
backhoe with boom parallel to tractor (Refer to Photo 1) -Connect backhoe tractor 3.P.L lower Arm (Refer to Photo 2)
-Connect solid top link at tractor end first (Refer to Photo 3) -Fit short bolt to rear hole loosely (use podgy bar to align holes)
( Refer to Photo 4) -Connect A-frame lockout bars to aligning holes and ensure all bolts are tight (Refer to Photo 5) -Connect
PTO shaft for BHUF & BHUS Model (Refer to Photo 6)
[12]