4/8
Plug for the TV Lift
Plug for the power cord
Plug for the pushbutton
10
9
7
1. Remove the packaging and check all components for completeness according to list of content on
page 3. The TV Lift is delivered partially pre-assembled. Already mounted fasteners are not listed
again. Due to shipping reasons, one only has to attach the TV-holder.
Because of the size and then weight of the TV Lift, two people should do the assembly.
2. Check the operating functions of the TV Lift. Please proceed as follows:
- Place the TV Lift in an upright position.
- Connect the cable of the lift column with the connecting cable .
- Plug the connecting cable in the control box .
- Connect the control box with a power outlet. The control-LED shines green.
- Connect the pushbotton with the control box . Move the lift upward for a few centimeters
and then down again by pushing the „UP/DOWN“ buttons. The control-LED shines red.
3. Attach the TV Lift vertically to a floor board or a back plate using the 6 mounting holes at the sides
of the mounting plate or alternatively the 4 mounting flabs alongside the lift column .
Make sure that the lift column can be extended fully.
4. Make sure when assembling the TV Lift and the control box that there is enough room for the cables
so that they cannot get tangled up.
5. Plug the connecting cables , and into the control box .
6. Check the lift mechanism by extending the lift column all the way.
MONTAGE
