BotKits.com D2 COMBAT ROBOT KIT, Инструкция по эксплуатации, Страница: 3 / 8

2 | P a g e
3 A
SSEMBLY
:
3.1 S
TEP
1 – T
EMPORARY ASSEMBLY
:
Form the basic chassis by assembling the 2 sides, 2 ends, 4 motors, switch, and power LED:

Attach all 4 of the plastic motor braces to the aluminum end pieces using the supplied #6 x 5/8”
flat head sheet metal screws and a #2 Phillips screwdriver.

Slide the motors into the motor bores, until just the black head of the motor (where the shaft
comes out) is extending beyond the side of the robot.

Loosely install 4 of the 10‐24 x 3/4 socket head cap screws in the lower holes on each end (e.g.
floppily) to connect the ends to the sides. There is no up/down/left/right. All of the sides and
ends can be used in any position (the large hollowed out areas go towards the insides).

Snug (e.g., finger tight) the 4 screws so the motors are temporarily held in place.

Attach the aluminum bottom plate to the chassis using 4 of the M3x6mm machine screws and
the included Torx screwdriver.