Boston Whaler 325 Conquest, Руководство пользователя

Страница: 116 / 207

4-3
Chapter 4 • Electrical
R
325 Conquest
13
1 2
4
5
GYRO* (OPTION) BATTERY COMPARTMENT
GYRO* REMOTE BATTERY SWITCH
GYRO* 100 AMP BREAKER
GYRO* BATT CHARGER REMOTE DISPLAY
GYRO* BATTERY
*Gyroscopic stabilizer
1
2
3
4
5
Remote Battery Switch Locations
(Figure 4.3.1)
The bow thruster battery
switch has two settings:
OFF - No power to bow
thruster.
ON - Power to bow
thruster
Bow Thruster Switch
This vessel uses a battery
switch for the bow thruster
(if equipped) to control
delivery of DC power from
the batteries.
The battery switch is located
on the port bulkhead inside
the aft bilge compartment.
O
ON
II
OFF
O
ON
II
OFF
O
ON
II
OFF
Batteries are automatically connected in parallel
through the use of automatic charging relays (ACR)
when a sufficient charging source is present. The
battery banks are automatically separated when the
charging source falls below a certain voltage level
for a predetermined amount of time.
The use of automatic charging relays eliminates the
need for the operator to monitor battery voltage and
decide whether or not to parallel the battery banks. It
also eliminates the chance of a dead battery bank if a
paralleling switch were left in the combined position
without a sufficient charging source present. In an
emergency, the operation of the automatic charging
relays can be manually overridden by use of the knob
on the top of the automatic charging relays.
Automatic Charging Relays (ACR)
REFER TO THE OWNER’S PACKET FOR COMPLETE
INSTRUCTIONS AND WARRANTY INFORMATION.
Manual Control Override
Each of the remote battery switches and automatic
charging relays have a manual override knob as
an added level of safety that allows manual on/off
control with or without power and provides lock off
for servicing the electrical system.
Manual Control Override Knob Operation
To combine
battery banks
With Override Knob in
( REMOTE position) push
button until latched (push to
latch on
).
To isolate battery
banks that are
connected
1. Rotate Override Knob to
right to release button from
latch on mode (button pops
up). 2. Rotate Override Knob
to left ( REMOTE position).
To prevent remote
operation.
Rotate Override knob to right
(
LOCK OF
F position).
To secure for
servicing.
With Override knob in (
LOCK
OFF position), pass cable tie
through hole.
1
2