Boston Whaler 280 Outrage, Руководство пользователя

Страница: 102 / 161

3-29 280 Outrage
Section 3 • Systems & Components Overview & Operation Section 3 • Systems & Components Overview & Operation
R
• Be sure there is adequate rode.
• Secure rode to both the anchor and the boat.
• Stop completely before lowering the anchor.
• Keep feet clear of lines.
NOTE: If using the optional windlass, refer to
the windlass operator’s manual for anchoring
instructions
To weigh (retrieve) the anchor, start the boat and run
slowly up to the anchor, taking up the rode as you
go. The anchor will usually break out when the rode
becomes vertical. Coil lines to let them dry before
stowing. The bow storage compartment located in
the starboard bow should be used to stow the anchor
line.
Weighing the Anchor
There is no best way to set an anchor. Experiment to
see how it performs. One method is to turn the rode
around a bitt or a cleat and slowly pay out as the boat
Setting the Anchor
Lowering The Anchor
Because there are a variety of anchors, for a variety
of uses, discuss the types of anchors with your
dealer to find the right anchor for your boat.
NOTICE
Before using the anchor be sure the anchor line
is attached to the eye in the bottom of the bow
locker, and to the anchor, securely.
Be careful that trailing lines do not foul in the
propeller
!
CAUTION
NOTICE
Turn on the anchor light when at anchor or
drifting (not under power) at night or in low
visibility.
Keep hands, feet, hair and loose clothing clear
of moving parts (anchor, rode, etc.). Entangle -
ment may cause severe bodily injury (i.e. lose
of fingers or toes).
!
WARNING
backs from the anchor site. When the proper scope
has been reached snub the rode quickly, causing the
anchor to dig in to the sea bottom.
• Reverse the engine slowly to drive
the anchor in and to prevent it from
dragging.
• Secure the rode to a bitt or cleat.