Wall or Ceiling Mounting Your VR-M/EX Speaker
The VR-M/EX is designed to be mounted directly onto a wall or ceiling. First attach the four
supplied self-adhesive felt pads, one on the back of each corner of the speaker. Then attach the
bracket to the wall or ceiling and slide the speaker on to the bracket as shown below and on the
two next pages.
You may run wires to the speakers on the wall surface or behind the wall. Use the recessed area on
the back of the speaker to accommodate the wire slack.
MOUNTING TIPS:
Use the supplied template to aid in positioning the mounting bracket.
At
least 4 inches of clearance is required between the top of the template and the ceiling.
Please
take care that the mounting brackets are attached securely to the chosen surface. Toggle bolts are
supplied for use on drywall or hollow plaster walls. Alternatively, you may wish to obtain wood
screws for wood or wall studs, molly bolts or screw anchors for drywall or plaster walls, or masonry
anchors for masonry walls. You can also just place the speakers to sit upright on a shelf or other flat
surface. In this case, be sure to use the supplied self-adhesive rubber feet to prevent any possible
slippage.
Mounting on drywall, paneling or other hollow surfaces:
Use the 6-32 x 2" machine screws and
toggle wings provided. The toggle wings require a
1
⁄
2
" (12mm) hole.
Mounting on wood and other solid surfaces:
Use a #6 or #8 wood screw.
Mounting on masonry, adobe and similar surfaces:
Consult a knowledgeable installer about
proper hardware. You will obtain best results with #6 or #8 wood screws.
4
INCLUDED HARWARE
(1) mounting
bracket
(2) toggle wing screws
(4) rear felt pads
for wall mounting
(4) rubber feet for
shelf mounting