Step Three: Mounting the P4 to the Stand
1. Using the speaker screws (long) and speaker screws
(short), mount the P4 wall bracket to the P4TS post.
The wall bracket is threaded to accept the speaker
screws. Use the speaker screws (long) on the upper
two threaded inserts and the speaker screws (short)
on the lower two threaded inserts.
2.
Mount the retaining screws (included with P4 speaker)
and connect the speaker wire to the terminals on the
back of the P4 Speaker.
3.
Slide the speaker into the retaining channels. The
speaker is held in place by gravity.
Note: For detailed instructions on installing the speaker to the wall
bracket, please refer to the P4 owners manual.
4.
Take up any slack in the speaker wire by
gently
pulling the wire at the opening in the base.
P4 Horizontal Mount Assembly Instructions:
This configuration is compatible with Models: P460,
P450, P442, P430, and P400.
Hardware / Parts:
Required Tools:
Speaker
Screw
(long) x 2
Threaded
Machine
Screw x 3
P4TS
Base x 1
P4TS
Horizontal
Post x 1
Step Two: Speaker Wire
With the stand still inverted, route
the speaker wire through the
opening in bottom of the base, down
through, and out the opening near
the top of the post. Leave several
extra inches of speaker wire exposed
to ease connection with the P4
speaker.
Step One: Attach Base
Attach the base to the horizontal
post with the three included
threaded machine screws and
split washers (small) using a
Phillips head screwdriver. The
post has already been threaded
to ease screw installation. Attach
rubber feet to base.
•Flat head
Screwdriver
•Phillips head
Screwdriver
Speaker
Screw
(short) x 2
Split Washer
(small) x 3
