INSTALLATION INSTRUCTIONS
6. The GT-RSL can be removed from bracket
mount for flush installation by sliding knob
off and removing attachment nut.
Cut out diameter is
5
⁄
16
" (7mm )
2. Remove (2) screws securing amplifier GT-
RSL cover plate marked "
subwoofer level
".
1. Completely power down the audio system
in the vehicle and remove the negative
cable from the vehicle's battery.
3. Align the GT-RSL Control PC Board into
the port slots on the amplifier and gently
press into place until seated. The GT-RSL
PC Board should fit into amplifier without
force.
4. Install the GT-RSL cover plate over the
socket and tighten screws.
5. Determine a location for the RSL control
in the front of the vehicle. Screws are
supplied for bracket mounting the GT-RSL.
