background image

6

7

Rear Stand Installation Instructions

the Boston Bravo 20 can be used horizontally on an untilted flat 
surface, such as a table, shelf or the top of a rear projection tV using 
the included rear bracket stand. 

first mount the speaker to the bracket (see above). 

next, place the speaker in the location that you intend to use it 
in (ie, correct grille/logo and tweeter/woofer orientation). Hold 
the stand in an upright position as indicated (note that the stand 
angles away from the bracket). line up the stand with the lower slot 
in the bracket so that the 2 middle “fingers” are on either side of the 
web that bisects the slot. slightly angle the stand away from the 
bracket and push the stand fingers up into the slot so that the 4 in-
ner “fingers” are placed inside the slot and the 2 outer “thumbs” are 
placed outside the slot. gently push the stand up into the bracket 
slot until the “fingers” and “thumbs” snap into place.

attach the rubber feet to the stand and cabinet  
(detailed on page 4).

4 inner "fingers"

2 outer "thumbs"

web in slot

Push stand  
into bracket  
slot until 
“fingers” and 
“thumbs” click  
into place

Stick a rubber foot to both 
pads on the stand and to both 
lower corners of the cabinet 
(do not apply to grille)

Mounting Possibilities of the Bravo 20

We designed the Bravo 20 to be mounted or placed in a wide variety of configurations.  shown below are seven of the most 
common possibilities for you to consider.

Rotating the Logo for Horizontal Mounting or Placement

the logo plate on the Bravo 20’s grille can be rotated 90° in either 
direction to enhance the speaker’s appearance when mounting 
or placing it in a horizontal position. to rotate the logo: 

remove the grille and turn it over.

locate the logo’s spring loaded post protruding through the 
bottom inside portion of the grille.

place your thumb against the post and press firmly until the logo 
pops forward.

rotate the logo to the desired position and release pressure on 
the post allowing it to snap back into the seated position.

Listening Levels and Power Handling

the listed power recommendations in the specifications section assume you will operate your system in a way that will not 
produce distortion. even these rugged speakers can be damaged by a modest amplifier if it produces distortion. if you hear a 
harsh, gritty noise, turn down the volume. prolonged or repeated operation of your speaker with a distorted signal from the 
amplifier can cause damage that is not covered by the warranty.

Limited Warranty

Boston acoustics warrants to the original purchaser of our passive loudspeakers that they will be free of defects in materials 
and workmanship for a period of 5 years from the date of purchase. Your responsibilities are to install and use them according 
to the instructions supplied, to provide safe and secure transportation to an authorized Boston acoustics service representative, 
and to present proof of purchase in the form of your sales slip when requesting service. excluded from this warranty is dam-
age that results from abuse, misuse, improper installation, accidents, shipping, or repairs/modifications by anyone other than 
an authorized Boston acoustics service representative. this warranty is limited to the Boston acoustics product and does not 
cover damage to any associated equipment. this warranty does not cover the cost of removal or reinstallation. this warranty 
is void if the serial number has been removed or defaced. this warranty gives you specific legal rights, and you may also have 
other rights, which vary from state to state.

All Other Countries
Contact the dealer from whom you purchased the product or contact your local distributor.  
For more information, please visit bostonacoustics.com/support

United States

first, contact the dealer from whom  
you purchased the product. if that is  
not possible, send an email to:  

[email protected]

or write to: 
Boston acoustics, inc.
100 corporate Drive
mahwah, nJ 07490 usa

Canada

first, contact the dealer from whom  
you purchased the product. if that is  
not possible, send an email to:  

[email protected]

or write to:   
D&m canada
5-505 apple creek Blvd
markham, on  l3r 5B1

If Service Seems Necessary

Содержание Bravo 20






Отзывы: