Boss LDR 14/16, Инструкция по установке и эксплуатации

Страница: 7 / 16

7
Box Plow Assembly Procedure
Box Plow Assembly Procedure
Note: This manual is used for the assembly of the
BOSS LDR 14/16 trip-edge box plow. Part numbers for
the BOSS LDR 14/16 trip-edge box plow are listed on
the parts diagram in this manual.
slide the wing brace (5) into the wing slot.
5.
Rotate the brace to line up with the tabs on top of the
blade.
6.
Insert the HDW16843 ¾
”
-10x4½
”
bolt (21) through tabs
and brace (5), then tighten the HDW03037 ¾
”
-10 nylon
lock nut (22).
7.
Slide the wing arm bushing (25A) onto the wing brace.
Insert the
HDW16843 ¾
”
-10x4½
”
bolt (25B) through the
attachment bushing and brace. Tighten the HDW03037
¾
”
-10 nylon lock nut (25C).
Figure 2. Wing Attachment
G10848
1.
Remove the blade assembly from the blade crate using
the fork pockets provided, or by removing the fork
pockets and using the lift points on the blade. Keep the
crate hardware as some of it will be used to assemble
the blade.
2.
Apply grease to wing bushing/pin tubes then insert left
wing (4) and right wing (3) into their corresponding
mounts on blade (1 or 2). Use lift points if necessary for
alignment.
3.
Secure the wings by inserting the HDW16843 ¾
”
-
10x4½
” bolt
(21) through the mounting tube. Then
tighten the HDW03037 ¾
”
-10 nylon lock nut (22).
Figure 4. Slip Hitch Assembly
G10850
8.
Insert the two lower HDW16844
1”
-8x4½ (26A) bolts on
each hitch and place the HDW07704
1”
-8 top lock nuts
(26B) and finger tighten.
9.
Slide back shim (13A) into the hitch, then with the shim
plate pushed towards the back of the hitch, slide in the
fork assembly (12).
10.
Slide the side shims into the hitch in front of the fork
assembly (12). Apply grease in-between the fork
assembly (12) and the back shim (13A) and side shims
(13B).
11.
Place the top caps (14) on top of the hitch and insert
the top
HDW16844
1”
-8x4½ (26A) bolts. Place the
HDW07704
1”
-8 top lock nuts (26B) on and finger
tighten.
12.
Tighten all fasteners.
Figure 3. Wing Brace Attachment G10849
4.
With the blade supported by fork pockets or lift points,
21
22
25B
25A
25C
5
26B
13A
12
13B
26A
14
GREASE
GREASE
GREASE
LIFT POINTS
(CAN USE FORK POCKETS)
4
21
3
1(2)
22