Boss Snowplow VBX 6500, Руководство пользователя

Страница: 18 / 32

Unloading the Spreader
Important:
Do not leave material in the hopper as
it could damage the machine.
1. Position the spreader in the area where you
want to deposit the material.
2. Unplug the spinner harness from the main wire
harness.
3. Remove the left latch and cotter pin from the
spinner assembly (
Figure 20 ).
g029500
Figure 20
1. Latch and cotter pin
4. Swing the spinner assembly free from the
hopper opening (
Figure 20 ).
Note:
Do not move the vehicle when the
spinner assembly is swung out.
5. Push and hold the dump switch to unload the
hopper material.
CAUTION
The spreader throws material at a high
speed that could cause minor injuries.
Stand to the side of the spreader when
activating the dump switch.
6. Swing the spinner assembly back into place
and secure it with the previously removed
attachment pin and cotter pin.
7. Connect the spinner harness to the main wire
harness.
Removing the Spinner
Assembly
1. Position the spreader over a flat, dry surface.
2. Unplug the spinner harness from the main wire
harness.
3. Remove the 2 latch and cotter pins securing the
spinner assembly to the hopper (
Figure 21 ).
g265081
Figure 21
1. Latch pin 3. Spinner assembly
2. Cotter pin
4. Remove the spinner assembly.
DANGER
The spinner assembly is heavy and could
cause serious injury if dropped.
Ensure that your footing is stable, and
avoid removing the spinner assembly
near slippery or uneven surfaces.
5. Insert the attachment pins and cotter pins into
the spinner assembly for storage.
18