Boss Snowplow STB08980, Руководство по установке, Страница: 20 / 36

5. Push the SmartHitch2 switch on the side of the
coupler tower upward and raise the tower until
the coupler spring pins snap in (
Figure 35 ).
g032912
Figure 35
1. Kickstand 3. Coupler tower
2. SmartHitch2 switch 4. Coupler spring pin
6. Ensure that both coupler spring pins have fully
engaged the coupler (
Figure 34 ).
Note:
Move the coupler tower until the spring
pins engage completely.
7. Pull the kickstand spring pin outward and raise
the kickstand, then release the spring pin to
secure it (
Figure 35 ).
8. Switch the headlight toggle switch to the P
LOW
position.
Checking the Hydraulic
Fluid Level
1. With the plow mounted to the vehicle, lower the
plow to the ground and ensure that it is in the
straight position.
2. Clean the area around the fill cap ( Figure 36 ).
g032934
Figure 36
1. Fill cap 2. Fill elbow
3. Remove the fill cap from the hydraulic reservoir
(
Figure 36 ).
4. Ensure that the fluid comes up to the bottom of
the fill elbow. If it does not, add more hydraulic
fluid; refer to
Adding Hydraulic Fluid (page 20) .
5. Install the previously removed fill cap.
Adding Hydraulic Fluid
1. Ensure that the lift cylinder is completely
collapsed.
Note:
The lights should tilt forward.
Important:
Do not manually pull the tower
down. This can cause an air pocket to form
in the hydraulic system and fluid to spill out
of the internal filler cap.
2. Clean the area around the fill cap ( Figure 36 ).
3. Remove the fill cap from the hydraulic reservoir
(
Figure 37 ).
4. Slowly fill the reservoir with BOSS
high-performance hydraulic fluid to the
bottom of the fill elbow (
Figure 37 ).
Note:
The reservoir holds approximately 1.9 L
(2.0 US qt) of hydraulic fluid.
20