Boss Snowplow STB08980, Руководство по установке, Страница: 18 / 36

SmartHitch2 Switch
The SmartHitch2 switch controls the movement of
the coupler tower to facilitate plow attachment and
removal. Press the switch up to raise the tower and
down to lower the tower.
Couplers
The couplers secure the plow to the vehicle push
beam. Turn the levers toward the coupler tower to
turn on the spring pins. Turn the levers away from the
coupler tower to turn off the spring pins.
g032941
Figure 30
1. Coupler tower 3. Coupler spring-pin
2. Pin receiver 4. Coupler lever
Headlight Toggle Switch
The headlight toggle switch controls which set of
headlights is being used. Move the switch to the
T
RUCK
position to use the headlights on the vehicle.
Move the switch to the P
LOW
position to use the
headlights on the plow.
Joystick Controller
The joystick controller operates the movement of the
snowplow.
g033061
Figure 31
1. Joystick 2. O
N
/O
FF
switch
•
O
N
/O
FF
switch—turns the plow controller on and
off. A red light will illuminate when the controller
is on.
Note:
Turn off the controller when not in use to
prevent accidental activation of the plow.
•
Directional joystick—controls the direction that the
plow moves
– To raise the plow blade, pull the joystick back.
– To lower the plow blade, push the joystick
forward.
– To angle the plow blade right, push the joystick
right.
– To angle the plow blade left, push the joystick
left.
– To activate the F
LOAT
feature, push the joystick
forward until it clicks into the detent position,
allowing the plow blade to follow the contour
of the ground. The joystick stays in the F
LOAT
position until the joystick is centered again.
18