Boss Snowplow MSC13960, Руководство пользователя

Страница: 6 / 16

5. Moving back and forth between bolts, secure
the pin channel in place by torquing the bolts to
42 N∙m (31 ft-lb).
Note:
Ensure that the pin slides easily in and
out.
6. Lower the A-frame until the plow rests on the
ground.
7. Shut off the machine engine, wait for all moving
parts to stop, engage the parking brake, and
remove the key.
8. Connect the angle-cylinder hydraulic hoses to
the quick disconnects on the machine (
Figure 8 ).
9. Raise the kickstand.
10. Start the machine.
11. Use the controls to move the plow in all
directions to cycle the hydraulic fluid.
Note:
If the blade hoses contact the plow
frame, adjust the 90° fittings upward.
12. With the hydraulic cylinder fully extended, shut
off the engine and wait for all moving parts to
stop.
13. Clean the area around the cap and the filler neck
of the hydraulic tank (
Figure 9 ).
g031401
Figure 9
1. Hydraulic-tank cap 2. Fill level
14. Remove the cap from the filler neck, and add
fluid to the reservoir until it reaches the fill level
(
Figure 9 ).
Important:
Do not use standard BOSS
hydraulic fluid in this system. Refer to your
Grandstand Multi Force
Operator’s Manual
for the appropriate hydraulic fluid.
Note:
The fluid level should be at the full mark
with the lift cylinder fully extended.
15. Install the cap on the filler neck.
16. Repeat steps 11 through 15 until all of the
hydraulic cylinders extend and retract smoothly.
Note:
If the hydraulic cylinders do not extend
and retract smoothly, there is still air in the
hydraulic lines.
WARNING
Hydraulic fluid escaping under pressure
can penetrate skin and cause injury.
• If hydraulic fluid is injected into the
skin, it must be surgically removed
within a few hours by a doctor familiar
with this type of injury. Gangrene may
result if this is not done.
• Keep your body and hands away from
pinhole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find
hydraulic leaks.
• Safely relieve all pressure in the
hydraulic system before performing
any work on the hydraulic system.
• Make sure that all hydraulic-fluid
hoses are in good condition, and
all that the hydraulic connections
and fittings are tight before applying
pressure to the hydraulic system.
6