Boss Snowplow MSC13960, Руководство пользователя

Страница: 5 / 16

2. Hook the 2 trip springs through the holes on the
push frame (
Figure 5 ).
g334232
Figure 5
1. Eyebolt 3. Nylon locknut (1/2 inch)
2. Washer (1/2 inch) 4. Trip spring
3. Hook the other ends of the trip springs to 2
eyebolts (
Figure 5 ).
4. Insert the threaded end of the eyebolts through
the holes on the plow blade and secure them
using 2 washers (1/2 inch) and 2 nylon locknuts
(
Figure 5 ).
5. Tighten the nylon locknuts until there is a gap of
0.8 mm (1/32 inch) between the trip spring coils.
6. Loosely attach the pin channel to the push
frame using 4 bolts (3/8 inch), 8 washers (3/8
inch), and 4 nylon locknuts (3/8 inch) as shown
in
Figure 6 .
Note:
Do not tighten the bolts and nuts.
g037038
Figure 6
1. Pin channel
3. Washers (3/8 inch)
2. Bolt (3/8 inch) 4. Nylon locknut (3/8 inch)
Mounting the Plow
Note:
You must first install the Grandstand Low Flow
Hydraulic and Quick Attach kits before mounting the
plow.
1. Ensure that the plow is sitting upright, with the
kickstand lowered (
Figure 7 ).
g334233
Figure 7
1. Plow coupler 3. Coupler pin
2. A-frame coupler
2. Lower the A-frame on the machine completely;
refer to
Controls (page 7) .
3. Slowly drive forward until the A-frame coupler
contacts the plow coupler (
Figure 7 ).
4. Raise the A-frame until the coupler pin locks into
place (
Figure 8 ).
Note:
Ensure that the coupler pin also inserts
through the hole in the pin channel on the plow
coupler (
Figure 8 ).
g244392
Figure 8
1. Pin channel
3. Quick disconnects
2. Coupler pin
5