BO
TTO
M
BO
TT
OM
- DIN REAR-MOUNT (METHOD B)
Installation using the screw holes on the sides of the unit.
Fastening the unit to the factory radio mounting bracket.
5
2
4
3
2
5
a. Frame
b. Insert fingers into the groove in the front of
frame and pull out to remove the frame.
(When re-attaching the frame, point the side
with a groove down wards and attach it.)
c. Insert the levers supplied with the unit into
the grooves at both sides of the unit as
shown in figure until they click. Pulling the
levers makes it possible to remove the unit
from the dashboard.
- Trim Plate Installation:
Removing the unit
a
b
c
- PANEL OPEN/CLOSE OPERATION
1
C
D
IN
RE
SET
2
1. Press Open button
2. The CD slot will be accessible.
3. After CD is loaded or unloaded return the panel to its original position.
Before attaching the trim plate, the side with a "Bottom" Label stuck should be
at down side (as shown on diagram).
Push the trim plate against the main panel until it is fitted.
E - 3
1. Select a position where the screw
holes of the bracket and the screw
holes of the main unit become
aligned (are fitted) and tighten the
screws at 2 locations on each side.
2. Screw
3. Factory radio mounting bracket.
4. Dashboard or Console
5. Hook (Remove this part)
Note: the mounting box, outer trim ring,
and the sleeve are not used for method
B installation.
Содержание MP3-4100R
Страница 1: ...Size 139 x 216mm ...
