Bose Panaray 502A, Руководство по обслуживанию

Страница: 34 / 64

34
7. Speakon ® Connector Removal
7.1 Remove the 4 screws that secure the
connector to the connector panel (16).
7.2 Make a note of the wiring configuration
and cut the connector's leads as close to its
terminals as possible. Remove the connec-
tor from the array.
Re-assembly Notes:
1. Observe polarity when connecting the
replacement XLR connector. Use the notes
from step 6.2.
2. When re-installing the connector, ensure
that the gasket is correctly positioned so that
it makes an airtight seal.
8. Fuseholder Removal
8.1 Remove the connector panel using
procedure 4.
8.2 Remove the fuseholder nut (26) from the
fuseholder body (19).
8.3 Unsolder the wires from the fuseholder
terminals.
502B Bass Module Procedures
Note: Refer to Figures 11 and 12 for the
following procedures.
9. Access Panel Removal
9.1 Remove 12 screws (23) that secure the
access panel (10) to the unit.
9.2 Partially insert one of the screws into a
screw hole. Using the screw as a lever,
carefully remove the access panel.
10. Woofer Removal
10.1 Remove the access panel using proce-
dure 9.
10.2 Remove the 8 screws (21) that secure
the woofer (22) to the unit.
DISASSEMBLY PROCEDURES
10.3 Make a note of the wiring configuration
and disconnect the wires from the woofer
terminals. Carefully pull the woofer away
from the unit.
Re-assembly Notes:
1. Observe polarity when connecting the
woofer harness wires to the woofer.
2. Align the woofer gasket to provide an
airtight seal.
11. Barrier Strip Connector Removal
11.1 Remove the 2 screws (16) that secure
the connector (17) to the access panel (10).
11.2 Make a note of the wiring configuration
and unwrap the wires from the connector
terminals. Remove the connector.
Re-assembly Notes:
1. Use the note from step 10.2 to ensure
proper wiring connections.
2. Align the connector gasket to provide an
airtight seal.
12. XLR Connector Removal
12.1 Remove the 4 screws (16) that secure
the connector (17) to the access panel (10).
12.2 Make a note of the wiring configuration
and cut the connector leads as close to the
terminals as possible. Remove the connec-
tor.
Re-assembly Notes:
1. Use the note from step 12.2 to ensure
proper wiring connections.
2. Align the connector gasket to provide an
airtight seal.
13. Fuseholder Removal
13.1 Remove the access panel using proce-
dure 9.
13.2 Remove the fuseholder nut (19) from
the fuseholder body (12).
13.3 Unsolder the wires from the fuseholder
terminals.