Installation and connection
en
13
Installation loca-
tion
Requirements
Base
Secure the appli-
ance with fixing
brackets
→
Wooden joist
floor
Place the appli-
ance on a water-
resistant wooden
board (minimum
thickness of
30 mm) which is
screwed tightly to
the floor.
Kitchen unit
Only install the
appliance under-
neath a continu-
ous worktop that
is securely con-
nected to adja-
cent cabinets.
Required niche
width: 60 cm.
Against a wall
Do not trap the
hoses between
the wall and the
appliance.
4.4 Removing the foam block
To prevent damage during transit, the
appliance is fitted with a foam block,
which must be removed before using
the appliance for the first time. If in
doubt, contact a specialist to have it
removed.
WARNING
Risk of injury!
When the appliance is tilted, the ap-
pliance may tip over.
▶
Tilt the appliance carefully.
▶
Do not tilt the appliance on your
own.
ATTENTION!
If the foam material is not removed, it
can cause damage to the appliance
when it is operated.
▶
Before starting up the appliance,
remove the foam block in its en-
tirety.
Note:
Remove the foam block first
before you remove the transit secur-
ing devices.
1.
Tilt the appliance to the rear.
