en
Operating the appliance
18
Activating/deactivating: Touch and hold
button
5
(
Finish in
) for approx. 5 s.
The symbol
E
is indicated in the
display. If the button signal is activated,
an acoustic signal sounds.
■
E
lights up: The childproof lock is
activated.
■
E
flashes: The childproof lock is
active and the programme selector
has been adjusted. To prevent the
programme from terminating, reset
the programme selector to the initial
programme. The symbol lights up
again.
Note:
The childproof lock may remain
activated until the next programme
starts, even after the washer dryer has
been switched off. Then deactivate the
childproof lock before the programme
starts and, if required, re-activate after
the programme starts.
Reloading the laundry
When the programme has started, the
laundry can be reloaded or taken out as
required.
Select Start/
Reload
A
. The washer
dryer checks whether a reloading is
possible.
Notes
■
If there is a high water level, high
temperature or if the drum is
rotating, the door remains locked
for safety reasons and reloading is
not possible.
If the following is indicated on the
display panel:
A:02
+
PAUS
~
Reloading is not
possible. To continue the
programme, select the Start/Reload
A
button.
¼
+
OPEN
are lit
~
Reloading is
possible.
■
Do not open the door until
both
symbols
¼
+
OPEN
are lit.
■
Do not leave door open for
a prolonged period – water could
run out of the washing.
■
The reloading function cannot be
activated during the drying phase.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Select Start/
Reload
A
.
2.
Select another programme. If
required, adjust the default settings
and/or select additional functions.
3.
Select
Start
/Reload
A
. The new
programme starts from
the beginning.
Interrupting or ending the
programme
For programmes at high temperature:
1.
Select Inicio/
Pausa+Carga
(Start/
Reload
).
2.
To cool down laundry: Select
à
(
Rinse
).
3.
Select
Inicio
/Pausa+Carga (
Start
/
Reload).
For programmes at low temperature:
1.
Select Inicio/
Pausa+Carga
(Start/
Reload
).
2.
Select
0
(
Spin
)/
[
(
Empty
).
3.
Select
Inicio
/Pausa+Carga (
Start/
Reload
).
For drying programmes:
1.
Select
Secar Normal
(
Intensive Dry
)
or
Secar Suave
(
Gentle Dry
).
2.
Press button
Secar
(
Drying
), and
set drying time to 15 minutes .
3.
Select
Inicio
/Pausa+Carga (
Start/
Reload
).
