Bosch WTY87640WW, Инструкция по установке и эксплуатации

Страница: 15 / 44

Installation and connection
en
15
During installation ensure that:
■
The dryer is placed on a clean, level
and firm surface,
■
The mains plug can be accessed at
all times,
■
The air inlet on the dryer is kept clear
and there is sufficient ventilation,
■
The area around the dryer is kept
clean and
■
The dryer is levelled using the
threaded feet.
Note:
Check the alignment of the
appliance with a spirit level and
correct if necessary. Change the
height by turning the appliance feet.
All appliance feet must stand firmly
on the ground.
Incorrect alignment may cause high
noise levels, vibrations and improper
movement of the drum.
Note:
If in doubt, have the appliance
connected by a specialist.
Changing the side on which
the door is hinged
Proceed as follows to change
the side on which the door is hinged:
1.
Set the programme selector to the
"Off" position, disconnect the dryer
from the mains and open the door.
2.
Remove the screws from the dryer
and then remove the dryer door.
Note:
Use a T20 (Torx) screwdriver
only. Do not use any other tools to
change the side on which the door is
hinged.