Bosch WTW87468GR, Инструкция по установке и эксплуатации

Страница: 34 / 40

en
Faults and what to do about them
34
Note:
If you cannot rectify the fault yourself by turning the dryer off and then on again,
please contact our after-sales service.
Drying time too long?
■
The fluff filter may be dirty and cause a longer drying time. Clean the fluff fil-
ter.
■
If the air inlet on the dryer is blocked or not freely accessible, this may
increase the drying time. Make sure that the air inlet remains unobstructed.
■
The optimum ambient temperature for drying is between 15 °C and 30 °C.
Outside of this range, the drying time may increase.
■
Insufficient air circulation in the room may increase the drying time. Venti-
late the room.
Display panel goes off
and Start button flashes.
Not a fault. Energy-saving mode is active
~
Page 13 .
Residual water in the
condensation container
despite the dryer being
connected to the
condensation drain*.
Not a fault. If the condensation drain is installed, residual water remains in the
condensation container due to the dryer's self-cleaning function.
Humidity in the room
increases.
Not a fault. Make sure the room is sufficiently ventilated.
Power cut. The drying programme is interrupted. Remove the laundry and spread it out or
restart the programme.
Unusual noises when
drying.
Not a fault. Noises are produced by the automatic cleaning of the heat
exchanger
~
Page 30 .
The dryer feels cold
despite drying.
Not a fault. The dryer can dry efficiently at low temperatures using a heat pump.
Faults Cause/remedy
* Depending on the model