en
Faults and what to do about them
32
3
Faults and what to do about them
Faults and what to do about them
Faults
Cause/remedy
ð
on the display panel
and drying has been
interrupted.
■
Empty the condensate container and press the Start button
.
■
If the optional condensation drain is installed, the drain hose may be
blocked. Check the hose for deposits and flush the hose out.
ç
on the display panel. Clean the fluff filter and/or the heat exchanger, then select the Start button
.
Dryer does not start.
■
Mains plug plugged in or fuse checked?
■
program selected? Select a program.
■
Dryer door open? Close the door.
■
Childproof lock activated? Deactivate the childproof lock.
■
"Finish in" time selected? program starts after a delay.
Display panel goes off
and Start button flashes.
Not a fault. Energy saving mode is active
Creasing.
■
Creasing occurs when you have exceeded the maximum load or selected
the wrong program for the type of fabric. All the required information can
be found in the program table.
■
Remove clothes immediately after drying; creasing may occur if they are
left in the drum.
Water is leaking out.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
Change in the pro-
gramme duration dis-
played during drying.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length (except timed programmes).
Laundry is not dried cor-
rectly or is still too damp.
■
After the end of the program, warm laundry feels damper than it actually is.
Spread the laundry out and allow the heat to disperse.
■
Finely adjust the dryness level – this extends the drying time but does not
increase the temperature. Your laundry will become drier
■
Select a program with a longer drying time or increase the drying level. This
does not increase the temperature.
■
Select a timed program for subsequent drying of laundry that is still damp
.
■
Select timed program for a small load and individual items of laundry.
■
If you have exceeded the maximum load for the program, the laundry may
not be dried properly.
■
Clean the moisture sensor in the drum. The sensor may become covered by
a fine layer of limescale or residues of detergents and care products which
then impair its function. Your laundry is not being dried correctly
.
■
Drying has been interrupted as a result of a power cut, because the conden-
sate container is full or because the maximum drying time has been
exceeded.
Note:
See also the laundry tips
* depending on the model
