FITTING THE DIVERTER VALVE MOTOR AND CODE PLUG
i System Diverter Valve kit 6 720 645 222 (2012/09)
6
To connect the expansion vessel flexible pipe to the hydraulic manifold
situated to the left of the pump:
▶ Remove and discard the plastic cap from the expansion vessel flexible
pipe.
1. Refer to figure 8, release the retaining clip.
2. Remove and discard the orange plastic blanking plug (2) from the
pressure vessel connection at the hydraulic manifold.
Fig. 8
Blanking plug removal
1. Refer to figure 9 and insert the expansion vessel flexible pipe it to the
fitting on the pump.
2. Secure in place with the wire retaining clip.
Fig. 9
Expansion vessel connection
▶ Connect the pressure relief drain pipe to 15mm compression joint
using the compression nut and olive supplied in the literature/
hardware pack.
4
FITTING THE DIVERTER VALVE MOTOR
AND CODE PLUG
4.1
FITTING THE DIVERTER VALVE MOTOR:
1. Remove the diverter valve blanking plate by pulling it forwards to free
it from its location.
Fig. 10 Removing Diverter valve blanking plate
1. To fit the diverter valve motor, push the motor into the housing until
the motor “clicks” securely into place, ensuring that the actuator arm
locates into the middle of the “H” receptor on the motor.
2. Connect the plug of the diverter valve motor harness into the socket
on the diverter valve motor.
3. Slide the protective cover over the diverter valve motor.
Fig. 11 Fitting Diverter motor and cover
4.2
ACCESS TO THE CODE PLUG
1. Referring to figure 12, unscrew the three screws in the control panel.
2. Pull off the connections cover.
Fig. 12 Removing the connection cover
6720645222-05.1Wo
1.
2.
6720645222-06.1Wo
1.
2.
1.
6720645222-07.2Wo
3.
2.
1.
6720645222-08.2Wo
6720804530-01.1W
o
1.
1.
1.
2.
