Faults and what to do about them
en
45
3.
Drain the water.
4.
Pull the emergency release
downwards with a tool and release.
The door can then be opened.
Information on the display panel
Display
Cause/Remedy
Õ
■
Flashes fast + signal
: The door was opened and the water level is too high.
Close the door, continue the programme with
I
Start/Reload
button or
select
Spin
0
.
■
Flashes slowly
: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
Hot
The door cannot be opened after the drying programme due to the high tempera-
ture. The cooling process continues until the temperature in the drum has dropped.
|
■
Flashes
(no water supply): Water tap turned on? Filter in the water supply is
"Filter in the water supply is blocked" on page 43
Is the supply hose kinked or trapped?
■
Lights up
(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
w
lights up
The childproof lock is activated – deactivate it.
o
lights up
Too much foam has been detected and an additional wash cycle has been acti-
vated. Add less detergent to the next washing cycle with the same load.
E:18
■
The drain pump is blocked.
"Drain pump is blocked" on page 42
■
The drain hose at the siphon is blocked.
"The drain hose at the siphon is blocked" on page 43
E:35
alternating with
-10
(Suitable for special
models)
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
E:95
alternating with
End
when programme is
finished
No water detected in drying phase, may get bad drying result.
