en
Cleaning and maintenance
40
After the water has cooled down:
1.
Turn off the water tap so that no
more water can flow in and has to be
drained via the drain pump.
2.
Switch off the appliance.
3.
Disconnect the mains plug.
4.
Open and remove the service flap.
5.
Take the drain hose out of the
retainer.
Remove the sealing cap, allow the
water to flow out into a suitable
container.
Replace the sealing cap and place
the drainage hose in the retainer.
6.
Carefully unscrew the pump cover,
residual water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
7.
Place the service flap back on, lock
it into place, and close it.
Note:
To prevent unused detergent
from flowing straight into the drain
during the next wash, pour 1 litre of
water (without detergent) into
compartment
II
and start the
Spin
0
programme. Do the next wash as usual.
The drain hose at the siphon
is blocked
1.
Switch off the appliance.
2.
Disconnect the mains plug.
3.
Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
4.
Clean the drain hose and siphon
connecting piece.
5.
Reattach the drain hose and secure
the connection using the hose
clamp.
