Bosch WLK24261BY, Инструкция по эксплуатации и руководство по установке

Страница: 36 / 42

en
Positioning and connecting
36
Water connection
:
Warning
Risk of electric shock!
Danger of death if live parts are coming
into contact with water.
Do not immerse Aqua-Stop safety
device in water (contains an electric
valve).
Caution!
Water damage
The connection points for the water
supply hose and water drain hose are
under high water pressure. To prevent
leaks and water damage, you must
follow the instructions in this section.
Notes
■
In addition to the safety information
listed here, the local water and
electricity supplier may have special
requirements.
■
Only operate the washing machine
using cold mains water.
■
Do not connect the washing
machine to the mixer tap of an
unpressurised hot-water boiler.
■
Do not use a used supply hose. Only
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
■
If in doubt, have the appliance
connected by a technician.
Water inlet
Notes
■
Do not bend, squash, modify or cut
through the water supply hose
(otherwise its strength is no longer
guaranteed).
■
Only tighten the screw connections
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may become
damaged.
Optimum water pressure in the mains:
100-1000 kPa (1-10 bar)
■
When the tap is open, the water flow
is at least 8 l/min.
■
If the water pressure is higher than
this, a pressure-reducing valve must
be installed.
Connection
Connect the water supply hose to the
water tap (¾" = 26.4 mm) and to the
appliance (not necessary for Aqua-Stop
models):
■
Aquastop
■
Standard
Carefully turn on the tap and check that
the connection points are not leaking.
Note:
The screw connection is under
water pipe pressure.
Water outlet
Caution!
Water damage
If the attached drainage hose slips out
of the washbasin due to high water
pressure when draining the appliance,
leaking water may cause damage.
Secure the drain hose so that it cannot
slip out.