14
Special programmes
Fluff Clean
The drum must be empty.
This programme is designed to clean the drying cycle of any fluff
deposits. The washer-dryer uses the flashing symbol
7
(
Fluff removal
cycle
) in the display panel to show that this programme must be run. The
electronic cycle counter is then automatically reset. The
7
(
Fluff removal
cycle
) symbol goes out after the programme starts.
To run the
Fluff Clean
programme, proceed as follows:
Make sure that the drum is completely empty and close the door.
Set the programme selector to
Fluff Clean
.
Press the
Start/Pause
button.
You can also run the
Fluff Clean
programme at any time without
prompting from the appliance.
Rinse + Spin
:
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to
$
(Rinse stop) before starting the
programme
→
page
15.
Empty + Spin
:
Drain the rinsing water following a programme with
$
(Rinse stop)
→
page
15.
Turn the programme selector to
Empty + Spin
.
Set the spin speed to
$
(Rinse stop).
Press the
Start
/Pause button.
or
Drain
and
spin at the desired spin speed:
Turn the programme selector to
Empty + Spin.
Press the
Spin rpm
button repeatedly until the desired spin speed is
set.
Press the
Start/Pause
button.
i
i
