21
Washing results not
satisfactory.
Soiling worse than expected.
Select a suitable programme, e.g. a
programme with Prewash. Pretreat
stains if necessary.
Too little or incorrect detergent used.
Use the correct dosage of a suitable
detergent, in accordance with the
manufacturer's instructions.
Maximum load exceeded.
Select the correct load for the
programme.
Detergent residues on the
washing.
Some phosphate-free detergents
contain water-insoluble residues which
appear on washing as light specks.
Rinse washing again or change to
liquid detergent.
Brush washing after drying.
Grey residues on the
washing.
Soiling caused by ointments, grease or
oil
Wash the laundry using the maximum
detergent dosage and the maximum
permissible temperature – see the
care label.
Detergent dosage too low.
Programme terminated
unexpectedly.
The
Inicio/Pausa
(Start/Pause) button
has been pressed accidentally.
Press the button again to restart the
programme.
The fabric softener is not
completely flushed in or too
much water remains in the
compartment
i
.
The fabric softener compartment insert
is not correctly attached or is blocked.
Clean the fabric softener compartment
insert and fit it correctly in the
compartment
i
page 16.
No response from the
indicator lamps.
Power cut.
The programme continues when power
is restored. If you wish to
remove the laundry during a power cut,
you must first drain out the water
page 17. Check whether:
-the plug is plugged into the socket
correctly
-the circuit breaker (fuse) has tripped;
call the after-sales service. .
Washing machine door
cannot be opened.
D
(Rinse stop) selected.
Select the programme
[
(Empty)
and
press
Inicio/Pausa
(Start/Pause).
The programme is running or the door
is locked for safety reasons.
Wait until
“Ÿš
appears on the display
panel.
Power cut.
Unlock the washing machine door
mechanically.
Emergency release
To release the door mechanically in the event of a power cut:
Turn the programme selector to
Stop
(Off) and unplug the mains plug from
the socket.
Open the base panel and drain out the water
page 17.
Pull the emergency release downwards and open the door at the same time.
– Before opening the door, make sure that there is no water or hot
detergent solution in the washing machine.
Under no circumstances must you open the door with the emergency release
while the drum is still turning.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to
Stop
(Off) and disconnect the mains plug from the socket.
– Turn off the tap and call the after-sales service
page 22
.
