Bosch WGA254U0AU, Инструкция по эксплуатации и руководство по установке

Страница: 30 / 52

en
Programme default settings
30
0
Programme default
settings
Programme default settings
You can change the default settings for
selected programmes. The settings can
be changed even while the selected
programme is running. The effects
depending on the progress of the
programme.
6
Temp. °C
Before and after the programme starts,
you can change the temperature
setting, depending on what stage the
programme is in, by adjusting the
desired temperature on the display.
The maximum temperature that can be
set depends on the programme that has
been selected.
0
Spin Speed
Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme by adjusting the desired
speed on the display.
setting
2
:
2
=”No spin”. The rinsing
water is drained but there is no final
spin. The laundry stays wet inside the
drum, e.g. for items that should not be
spun.
You can select “No spin” to prevent
creasing if the laundry will not be taken
out of the appliance immediately after
the programme has ended.
The maximum speed that can be set
depending on the model and the
programme that has been selected.
ñ
Finished in
Before starting the programme
, you
can preselect the programme end
("Finish in" time) in 0.5h (h = hour)
increments (between “minimum
selectable ending time” and 9.5h) or 1
hour increments (between 10h and
24h) up to a maximum of 24 hours.
To do this:
1.
Select a programme (except
myTime
* programme).
The programme duration is
displayed for the selected
programme, e.g.
2:30
(hours:minutes).
2.
Select the
ñ
Finished in
button
repeatedly until the required number
of hours is displayed.
3.
Select the
Start/Reload
A
button.
The programme starts.
The selected number of hours (e.g.
8h
) is shown in the display panel
and counts down until the
programme starts. The duration of
the programme is then displayed.
Note:
The length of the programme is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
additional programme settings may also
change the programme duration.
After starting the programme
(if a
“Finish in” time has been selected and
the programme has not yet started), you
can change the preselected number of
hours as follows:
1.
Select the
Start/Reload
A
button.
2.
Select the
ñ
Finished in
button
repeatedly to change the number of
hours.
3.
Select the
Start/Reload
A
button.
* Depending on the model